安庆微信附近的人50块-安庆微信附近的人50块

绵阳附近有没有服务

 Crusher, mobile crusher, crusher

National hotline
 Crusher - crusher - China crusher home - website with ranking for sale
 Crusher - crusher - China crusher home - website with ranking for sale
Current location: China crusher home > Crushing equipment >

The bearing of sand making machine is easy to wear

Source: unknown Author: admin popularity: Time of publication: June 28, 2020 13:57

The bearing of sand making machine is easy to wear, and the parts bear most of the load of equipment operation. Therefore, we should use good lubricants and keep them clean at all times. If the lubricating oil is not clean, it will increase the wear of bearings, bearings and other parts. In addition, attention should be paid not to overheat the bearing, which will lead to the decline of bearing operation efficiency and affect the normal operation of the equipment. The driving device of sand making machine and the V-belt should be properly adjusted to ensure the uniform force on the V-belt. When the driving device is driven by double motors, it should be reasonably distributed with the same force.

 The bearing of sand making machine is easy to wear

The stability of the traditional sand making machine is not as good as that of the new sand making machine, and the maintenance rate is higher. But the price of traditional sand making machine is relatively cheap. But whether from the product performance or cost-effectiveness point of view, more people are willing to choose the new sand machine. It can improve the output better than the traditional sand making machine and reduce the environmental pollution to a very low level. After being used for a period of time, the cabin door should be opened to check the internal conditions of the sand making machine, the lining plates above and below the impeller, and the wear degree of wear-resistant materials. If any wear is found, it should be replaced in time to ensure the working efficiency of the sand making machine.

  The bearing of sanding machine is easy to wear

In a complete production line, there is not only a sand making machine, but also many equipment, such as jaw crusher, cone crusher, vibrating screen, conveyor, etc. The selection of these large-scale equipment is based on the solution of the whole process and its actual needs. Not all production lines need to be equipped with a new type of sand making machine. If the requirements for finished products are not high, the production line only needs one crushing and two crushing, and if the requirements for finished products are high, it is recommended to choose a new sand making machine.

Keywords: System sand machine